CP2102 chip from SiLabs is a single-chip USB to UART bridge IC. This cp2102 USB to serial requires minimal external components.CP2102 can be used to migrate legacy serial port based devices to USB.
ESP32-CAM-MB Programming Adapter Board CH340 Serial To USB for ESP32-CAM Module
ESP32-CAM-MB Programming Adapter Board WIFI+Bluetooth compatible TTL Downloader Module 4.7V-5.3V for ESP32-CAM Module Shield
MQ4 High Sensitivity Gas Methane (CNG) Detector Sensor Module is a simple to use MQ-4 High Sensitivity Gas Methane (CNG) Detector Sensor Module which can sense the presence of Compressed Natural Gas(CNG), methane(CH4), etc in the air. The module uses our MQ-4 sensor. It simplifies the interface to the odd pin spacing of the sensor and provides the interface through standard 4 x 0.1″ header pins. It provides an analog output corresponding to the concentration of the gases in the air and an easy to use digital output. The onboard potentiometer can be used to set the maximum gas concentration beyond which the digital output gets triggered. Just power the module with 5V set the threshold and you can start getting the gas concentration of the air around the sensor! An onboard LED signals the presence of any gas.
Sensitive material of MQ-7 gas sensor is SnO2, which with lower conductivity in clean air. It make detection by method of cycle high and low temperature, and detect CO when low temperature (heated by 1.5V). Electronicstor.pk
The MQ 135 Air Quality Detector Sensor Module For Arduino has lower conductivity in clean air. When the target combustible gas exists, the conductivity of the sensor is higher along with the gas concentration rising. Convert change of conductivity to the corresponding output signal of gas concentration. The MQ135 gas sensor has high sensitivity to Ammonia, Sulphide and Benzene steam, also sensitive to smoke and other harmful gases. It is with low cost and suitable for different applications such as harmful gases/smoke detection
Arduino-Like Hardware IO
Code like Arduino, but interactively in Lua script
Event-driven API for network applications, which facilitates developers writing code
Integrates GPIO, PWM, IIC, 1-Wire and ADC all in one board
10 GPIO, every GPIO can be PWM, I2C, 1-wire
4M Flash Memory
Built-in WiFi Antenna
RS485 to TTL / TTL to RS485 converter is a module that allows the TTL interface of the microcontroller to be transferred to the RS485 module / MAX485 module. It is generally used for industrial automation. This module adds lightning protection design and anti-jamming design. When we use it in the field and carry out long distance transmission, we can Connect the GND end of the module to the ground so that lightning protection and anti-interference can be achieved. This Max485 to TTL module is online in Pakistan
Reviews
There are no reviews yet.