Futaba S3003 Standard Servo Motor for RC Vehicles in Pakistan

This is 65mm Robot Wheel for Smart Robo Car Motor Chassis(Yellow). The wheel is made up of high-quality rubber which gives maximum traction while operating. The wheel is strong and sturdy as it features a nylon reinforced plastic rim. Features: Car hub is reinforced nylon, very sturdy. Tire with sponge liner for more strength With upgraded tire tread for greater friction New design wheel for better combination with the motor

Driver IC: PCA9685; Adjustable frequency PWM up to about 1.6 kHz; 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate; Reverse polarity protection on the terminal block input Configurable push-pull or an open-drain output; The output enable pin to quickly disable all the outputs; Terminal block for power input; Green power-good LED 3 pin connectors in groups of 4 so you can plug in 16 servos at once; Chainable design; A spot to place a big capacitor on the V+ line220-ohm series resistors on all the output lines to protect them, and to make driving LEDs trivial.; This board/chip uses an I2C 7-bit address between 0x60-0x80, selectable with jumpers Dimension:- Length: 62mm; Width: 25mm; Height: 15mm; Weight: 10gm