1000KV A2212 Brushless DC Motor BLDC Rotor for Quadcopter Drone

Driver IC: PCA9685; Adjustable frequency PWM up to about 1.6 kHz; 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate; Reverse polarity protection on the terminal block input Configurable push-pull or an open-drain output; The output enable pin to quickly disable all the outputs; Terminal block for power input; Green power-good LED 3 pin connectors in groups of 4 so you can plug in 16 servos at once; Chainable design; A spot to place a big capacitor on the V+ line220-ohm series resistors on all the output lines to protect them, and to make driving LEDs trivial.; This board/chip uses an I2C 7-bit address between 0x60-0x80, selectable with jumpers Dimension:- Length: 62mm; Width: 25mm; Height: 15mm; Weight: 10gm Packaged by:- Sharvi Technologies (OPC) Pvt. Ltd.; Address:- #09, CK Nagar, AECS layout, Hosa Road, Bangalore-560100

Power supply voltage: VM = 15 V(Max). Output current: IOUT=1.2 A(ave) / 3.2 A (peak). Output low ON resistor: 0.5Ω (VM ≥ 5 V). Built-in thermal shutdown circuit and low voltage detecting circuit. Thermal Shutdown Circuit. Heat Radiation Design. Back-EMF protection.

High current: The BTS7960 can handle up to 43A of peak current and 36A of continuous current. Low on-resistance: The BTS7960 has a low on-resistance of 16mΩ, which helps to minimize power dissipation. Low quiescent current: The BTS7960 has a low quiescent current of 7µA, which helps to extend battery life. Integrated driver IC: The BTS7960 includes an integrated driver IC that provides logic level control, current sense, slew rate limiting, dead time generation, and protection against overtemperature, overvoltage, undervoltage, overcurrent, and short circuit. IBT2 Motor Driver Specifications : – BTS7960 43A provides a cost optimized solution for protected high current PWM motor drives with very low board space consumption. The 43a motor driver IBT-2 H-bridge module is an inexpensive, high power motor driver based on two BTS7960 chips. If you are looking for a high-performance, low-cost, and easy-to-use motor driver, the IBT2 H-Bridge is a great option. Here are some of the specifications of the IBT2 H-Bridge: Input voltage: 6V to 27V Maximum current: 43A Control input level: 3.3V to 5V Control mode: PWM or level Working duty cycle: 0 to 100% Over-voltage lockout Under-voltage shutdown Board size (L x W x H): 50mm x 50mm x 43mm Weight: ~66g